Discussion:
Samsung ML-2510 problem
(too old to reply)
e***@yahoo.com
2008-01-20 16:24:28 UTC
Permalink
I've reinstalled the driver and the damn thing only prints after I
reboot. Any suggestions appreciated.

Thanks in advance,
TS
Tony
2008-01-20 20:06:23 UTC
Permalink
Post by e***@yahoo.com
I've reinstalled the driver and the damn thing only prints after I
reboot. Any suggestions appreciated.
Thanks in advance,
TS
Did you connect the cable ONLY after you installed the driver?
Tony
MS MVP Printing/Imaging
e***@yahoo.com
2008-01-21 04:02:53 UTC
Permalink
Post by Tony
Post by e***@yahoo.com
I've reinstalled the driver and the damn thing only prints after I
reboot. Any suggestions appreciated.
Thanks in advance,
TS
Did you connect the cable ONLY after you installed the driver?
Tony
MS MVP Printing/Imaging
Don't recall. I think after.
Tony
2008-01-21 04:09:24 UTC
Permalink
Post by e***@yahoo.com
Post by Tony
Post by e***@yahoo.com
I've reinstalled the driver and the damn thing only prints after I
reboot. Any suggestions appreciated.
Thanks in advance,
TS
Did you connect the cable ONLY after you installed the driver?
Tony
MS MVP Printing/Imaging
Don't recall. I think after.
Well it is important to only connect the printer when the installer asks you to
or when the installation completes.
Tony
MS MVP Printing/Imaging
e***@yahoo.com
2008-01-23 02:40:18 UTC
Permalink
Post by Tony
Post by e***@yahoo.com
Post by Tony
Post by e***@yahoo.com
I've reinstalled the driver and the damn thing only prints after I
reboot. Any suggestions appreciated.
Thanks in advance,
TS
Did you connect the cable ONLY after you installed the driver?
Tony
MS MVP Printing/Imaging
Don't recall. I think after.
Well it is important to only connect the printer when the installer asks you to
or when the installation completes.
Tony
MS MVP Printing/Imaging
Turns out the problem was the USB to parallel cable(port). Switched to
USB port on printer and works fine.

Thanks,
Joe
2008-01-23 16:48:09 UTC
Permalink
Not a bad printer- I got it for $30 and found an aftermarket supplier for
the cartridge- which I think cost about $30.
Post by e***@yahoo.com
Post by Tony
Post by e***@yahoo.com
Post by Tony
Post by e***@yahoo.com
I've reinstalled the driver and the damn thing only prints after I
reboot. Any suggestions appreciated.
Thanks in advance,
TS
Did you connect the cable ONLY after you installed the driver?
Tony
MS MVP Printing/Imaging
Don't recall. I think after.
Well it is important to only connect the printer when the installer asks you to
or when the installation completes.
Tony
MS MVP Printing/Imaging
Turns out the problem was the USB to parallel cable(port). Switched to
USB port on printer and works fine.
Thanks,
Loading...